Hello,
What can be the root cause(s) of this disconnection message:
Session disconnected (route "ROUTE2XXXXXX", host "69.184.254.21", port 14003). Text:<Impl/ripcsrvr.c:7093> Error:1002 ripcRead() failure. Connection reset by peer
Thanks
Hello,
What can be the root cause(s) of this disconnection message:
Session disconnected (route "ROUTE2XXXXXX", host "69.184.254.21", port 14003). Text:<Impl/ripcsrvr.c:7093> Error:1002 ripcRead() failure. Connection reset by peer
Thanks
Hi.
Thank you for your participation in the forum.
Are any of the replies below satisfactory in resolving your query?
If so please can you click the 'Accept' text next to the appropriate reply. This will guide all community members who have a similar question.
Else please post again offering further insight into your question.
Thanks
AHS
Please be informed that a reply has been verified as correct in answering the question, and has been marked as such.
Thanks,
AHS
From the TCP port (14003), a provider should be a non-interactive provider. Non-interactive provider will establish a connection to ADH.
I got the same error text (at a different line) if a non-interactive provider exited by closing the channel without closing the login stream.
Session disconnected (route "ripcSession.23", host "xxxx", port 14003). Text:<Impl/ripcsrvr.c:6868> Error:1002 ripcRead() failure. Connection reset by peer
However, if a non-interactive provider exited by closing the login stream and then closing the channel, ADH will show a different message.
Session disconnected (route "ripcSession.23", host "xxxx", port 14003). Source Application has closed login stream.
In conclusion, one scenario which can trigger this message in ADH log is that a non-interactive provider mayn't be properly shut down.
The above message means that whatever was connected on that port initiated a disconnection and shutdown the connection.
So, you will need to investigate whatever it was that was connected on that port (e.g. a provider app?)