Is there a way to configure RFA so that it can failover between two ADS's, One with Encryption Enabled and One with Encryption Disabled?
Is there a way to configure RFA so that it can failover between two ADS's, One with Encryption Enabled and One with Encryption Disabled?
Thanks for reaching out to us.
I checked the RFA configurations. RFA supports failover via the serverList configuration in the connection.
\Connections\Connection_RSSL\connectionType = "RSSL" \Connections\Connection_RSSL\rsslPort = "14002" \Connections\Connection_RSSL\serverList = "192.168.27.40, 127.0.0.1"
All servers in the serverList configuration use the same connection settings. Therefore, RFA can't be configured to failover between Encrypted and non-Encrypted ADS.
I hope that this information is of help.
As an alternative, would it be possible to setup "Warm Standby" between an Encrypted and Un-Encrypted connection?
I don't think so.
In RFA, the WarmStandbyGroup is specifed in the serverList parameter which is under a connection.