Failover between Encrypted and non-Encrypted ADS using RFA

Is there a way to configure RFA so that it can failover between two ADS's, One with Encryption Enabled and One with Encryption Disabled?

Find more posts tagged with

rfa

rfa-api

#technology

Accepted answers

Jirapongse

@ron.bove01

Thanks for reaching out to us.

I checked the RFA configurations. RFA supports failover via the serverList configuration in the connection.

\Connections\Connection_RSSL\connectionType                    = "RSSL"
\Connections\Connection_RSSL\rsslPort                         = "14002"
\Connections\Connection_RSSL\serverList                        = "192.168.27.40, 127.0.0.1"

All servers in the serverList configuration use the same connection settings. Therefore, RFA can't be configured to failover between Encrypted and non-Encrypted ADS.

I hope that this information is of help.

All comments

Jirapongse

@ron.bove01

Thanks for reaching out to us.

I checked the RFA configurations. RFA supports failover via the serverList configuration in the connection.

\Connections\Connection_RSSL\connectionType                    = "RSSL"
\Connections\Connection_RSSL\rsslPort                         = "14002"
\Connections\Connection_RSSL\serverList                        = "192.168.27.40, 127.0.0.1"

All servers in the serverList configuration use the same connection settings. Therefore, RFA can't be configured to failover between Encrypted and non-Encrypted ADS.

I hope that this information is of help.

ron.bove01

Thanks for that information. That's what we suspected.

As an alternative, would it be possible to setup "Warm Standby" between an Encrypted and Un-Encrypted connection?

EXPLORE OUR SITES